Discuss the characteristics of ADC in detail EEVibes

Adc Out Of Range. ADC out of range??? Temperatur überschreitet die Mindest oder Maximale Another cause could be due to an improperly configured heater in the config Once the underlying issue is corrected, use the "FIRMWARE_RESTART" command to reset the firmware, reload the config, and restart the host software

Post your printer.cfg specifically the heater section for the heater you just replaced, make sure all wires are securely connected and use. After that, I disconnected the ledstrip, took out the neopixel configuration and all was printing fine again.

ADC on TM4C YouTube

Klipper reports: SHUTDOWN MCU 'mcu' shutdown: ADC out of range This generally occurs when a heater temperature exceeds its configured min_temp or max_temp MCU 'mcu' shutdown: ADC out of range Sensor 'heater_bed' temperature -72.505 not in range .000:130.000 Sensor 'extruder' temperature 370.403 not in range .000:300.000 This generally occurs when a heater temperature exceeds its configured min_temp or max_temp 6: 378: September 14, 2024 Please help (MCU (ADC pin) Error) General.

MCU EBB can ADC out of range in Ender3v2 General Discussion Klipper. Post your printer.cfg specifically the heater section for the heater you just replaced, make sure all wires are securely connected and use. 6: 378: September 14, 2024 Please help (MCU (ADC pin) Error) General.

ADC Range Chart Infogram. After that, I disconnected the ledstrip, took out the neopixel configuration and all was printing fine again. ADC out of range" when the printer was at the last checkpoint of a bed levelling run before a print